Aeration equipment 3072 CLACK WS1.5 with oil-free compressor and pulse counter

7900.00 €
Compare products
WATER QUALITY PROBLEM
Iron and manganese often causes the main problem of the waterworks. When water gets in contacts with air, it changes the colour, turbidity increases and sediments appears. Water has a metallic taste. Water pipes are clogged and sanitation at the consumer becomes dirty. Suggested concentration of iron should be 0.2 mg/l and manganese 0.05mg/l.
 
SOLUTION
Aqaphor Aerācija series filters are designed to purify water from turbidity, colorfulness, iron, manganese and odor for private houses. Mainly it is used for groundwater purification.
 
OPERATING PRINCIPLE
When water is aerated, iron, manganese and mechanical impurities form sediment, which can be filtered. Suspended solids are filtered through filtering material, which has been poured in to filter. Filters depending on pollution levels and water consumption have to be rinsed regularly. Filters after rinsing are regenerated and can purify water. Equipment consists from reactor, filter and compressor.
 
PRESSURE TANK
Pressure filter tanks are made from fiberglass with inner PE coating that can hold pressure up to PN10.
 
FILTER MATERIAL        
For water purification filtering material Birm and quartz sand with different grain size (0.4-0.8 mm, 0.7-1.25 mm, 1-3 mm, 3-5 mm) is being used. 
 
CONTROL UNIT  
The filter is equipped with an automatic Clack control which performs filtering and rinsing sequences automatically. Usually rinsing is performed at 2:00 at night.
 
AIR SUPPLY        
For water aeration it is necessary to  install air compressor. Air is injected in the water before it enters reactor.
 
PRECONDITIONS        
The equipment need sewer and electricity 220V connection, input water pressure with a minimum pressure of 2.5 bar, the room temperature above 0° C, the water temperature to 25° C as well as correct system connection.
 
SYSTEM MAINTENANCE       
Filters will provide with good quality water if operating personnel will ensure proper air supply, and unnecessary air removal and regular rinsing processes. Water purification system does not require specific chemical admixtures that have to be refilled.  

Additional equipment options:
  • Condensate isolation for tank;
  • By-pass valve – For easier assembly.

Technical parameters of equipment

Parameters 

Unit

Аeration 3072

Flow rate  Qnom

m3/h

 

The amount of water for regeneration

m3

 

Minimum flow rate for rinsing

m3/h

 

Tank size (diameter)

inches

 

m

 

Tank volume

liters

 

The amount of filtering material

liters

 

Length

m

 

Width

m

 

Height

m

 

Connection. in /ext/kan.

inches

 

Управляющий блок Clack 

 

 

Filtration

 

Iron, manganese, turbidity, odor, colorfulness

Tank material

 

FRP (fiberglass)

Filtering material

 

Birm, silica sand 0.4x0.8 mm, 0.7x1.25 mm, 1x3 mm, 3x5 mm

Operating pressure

bar

2-6

Electric Connection

 

220V, 50Hz, 1 faze

Electricity consumption

W

3 W